EasyManuals Logo

Huawei SmartAX MA5608T User Manual

Huawei SmartAX MA5608T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1910 background imageLoading...
Page #1910 background image
access). The OLT and ONU work with upper-layer devices to support Huawei DS+NAT
+PPPoE/DS+NAT+IPoE HSI IPv6 solutions.
l For voice services: The ONU with a built-in voice module can directly provide VoIP
services for users. The ONU processes VoIP services using the IPv4 protocol instead of
the IPv6 protocol.
l For Internet access services: Users connect to the ONU through category-5 cables (LAN
access) or the modem and twisted pairs (xDSL access). The PC and BRAS support the
IPv4/IPv6 DS and can be connected in the PPPoE or IPoE mode. The OLT and ONU
implement Layer 2 forwarding, irrespective of whether the access service is IPv4 or IPv6.
Service configurations for IPv4 and IPv6 are the same. Only the ACL, anti-IP spoofing,
and DHCP option configurations for IPv4 and IPv6 are different.
Figure 19-4 FTTB/C (no HGW) networking
ONU
Phone
PC
Optical
splitter
ONU
P
O
T
S
LAN
NGN/IMS
Internet
UPE
PE-AGG
OLT
PE-AGG
UPE
PC
Phone
P
O
T
S
xDSL
FE/GE
Metro Network
BRAS CGN
19.3.2 Data Planning
This section describes the security, device management data, QoS, Internet service data, and
voice service data planning.
Security Planning
Security planning includes system security, user security, and service security, ensuring that user
services are provided properly from different dimensions.
In the FTTB/C (no HGW) networking scenario, the data for IPv6 and IPv4 security planning
differs only in anti-IP spoofing and DHCP option.
Anti-IP spoofing: This function needs to be configured separately for IPv6 services.
The anti-IP spoofing function can be enabled or disabled at three levels. This function takes
effect only when it is enabled at all the three levels.
1. Global level: Run the security anti-ipv6spoofing enable command in global config mode.
2. VLAN level: Run the security anti-ipv6spoofing enable command in VLAN service
profile mode.
3. Service port level: Run the security anti-ipv6spoofing service-port serviceport-id
enable command.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1885

Table of Contents

Other manuals for Huawei SmartAX MA5608T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5608T and is the answer not in the manual?

Huawei SmartAX MA5608T Specifications

General IconGeneral
Dual Power SupplyYes
Humidity5% to 95% (non-condensing)
Uplink Slots2
Maximum GPON Ports16
Input Voltage Range-38.4 V DC to -72 V DC
Device TypeOLT
Power Supply-48 V DC
Operating Temperature-25°C to +55°C
Storage Temperature-40°C to 70°C
Switching Capacity128 Gbps
PortsGPON, XG-PON, 10GE

Related product manuals