Item Data
FAN
l SN: 0
l Sub-node ID: 1 (default)
l Name: FAN
l Fan speed adjustment mode: automatic
ESC
l SN: 1
l Sub-node ID: 15 (default)
l Name: H801ESC
Route protocol
l Upstream port: 0/19/0
l Management VLAN ID: 100; type: Standard VLAN
l IP address of the L3 interface of the management VLAN:
10.50.1.10/24
l Gateway address: 10.50.1.1/24
l IP address of the target network segment: 10.10.1.10/24
The following displays the commands that need to be included in the script according to the
preceding data plan.
NOTICE
Each command in the script must end with a carriage return (CR).
enable
config
board add 0/21 H801PRTE
board add 0/22 H801PRTE
emu add 0 FAN 0 1 FAN
interface emu 0
fan speed mode automatic
quit
emu add 1 H801ESC 0 15 H801ESC
vlan 100 standard
port vlan 100 0/19 0
interface vlanif 100
ip address 10.50.1.10 24
quit
ip route-static 10.10.1.0 24 10.50.1.1
save
1.6.2 Configuring the File Transfer Mode
This topic describes how to configure the file transfer mode of the FTP,SFTP, Xmodem and
TFTP. SFTP with high security is recommended.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
194
To Next Page
Loading...
Need help?
General
