huawei(config)#save
Step 2 The ONU does not need to be configured.
----End
12.3.10 Configuring the VoD Service
The OLT is connected to the remote gateway ONU through a GPON port to provide users with
the VoD service.
Prerequisites
l The IPTV WAN ports on the ONU use factory defaults.
l The OLT has been connected to the BRAS and the program source.
l The ONU has been added to the OLT. For details, see 12.3.3 Adding an ONU to an
OLT.
Data Plan
Table 12-16 Data plan
Item Data
ONU line profile Profile name: ftto_line
T-CONT ID: 4
GEM port ID: 13
ONU service profile Profile name: ftto_ser
ONU port capability set: adaptive
Traffic profile ID: 8
802.1p priority: 4
CIR: off (unlimited)
Priority-based scheduling policy: local-setting
Procedure
Step 1 Configure the OLT.
1. Configure a traffic profile.
Configure traffic profile 8. Set the CIR to off (unlimited), priority to 4, and priority-based
scheduling policy to local-setting (that is, queues are scheduled based on the priority
specified in the profile).
NOTE
Run the display traffic table ip command to query existing traffic profiles in the system. If the existing
traffic profiles in the system do not meet the requirements, run the traffic table ip command to add a
traffic profile.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1134
To Next Page
Loading...
Need help?
General
