huawei(config)#service-port 2 vlan 1000 gpon 0/1/0 ont 2 gemport 13 multi-
service
user-vlan 1000 rx-cttr 8 tx-cttr 8
3. Create an MVLAN and configure the IGMP version.
Set the IGMP version for the MVLAN to IGMPv2.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v2
This operation will delete all IPv4 programs with source IP addresses in the
current multicast VLAN
Are you sure to change current IGMP version? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
4. Configure a program library.
Set the mode for obtaining multicast programs to dynamic.
NOTE
You can set the mode for obtaining multicast programs to dynamic only when the IGMP mode is off.
huawei(config-mvlan1000)#igmp mode off
Are you sure to close IGMP? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
huawei(config-mvlan1000)#igmp match mode disable
Command has been executed successfully
(Optional) Set the address range for the dynamic programs. If you need to limit the address
range of dynamic programs, perform this operation. For example, set the address range of
dynamic programs to 224.1.1.1-224.1.1.100.
huawei(config-mvlan1000)#igmp match group ip 224.1.1.1 to-ip 224.1.1.100
5. Set the IGMP mode.
Select the IGMP proxy mode.
huawei(config-mvlan1000)#igmp mode proxy
Are you sure to change IGMP mode? (y/n)[n]:y
Command is being executed. Please wait...
Command has been executed successfully
6. Configure the IGMP upstream port.
Set the IGMP upstream port ID to 0/19/0 and working mode to default. Protocol packets
are transmitted to all the IGMP upstream ports in the multicast VLAN.
huawei(config-mvlan1000)#igmp uplink-port 0/19/0
huawei(config-mvlan1000)#btv
huawei(config-btv)#igmp uplink-port-mode default
Are you sure to change the uplink port mode?(y/n)[n]:y
7. (Optional) Set multicast global parameters.
In this example, the default settings are used for all the multicast global parameters.
8. Configure multicast users.
Add service ports 1 and 2 as multicast users.
huawei(config-btv)#igmp user add service-port 1
huawei(config-btv)#igmp user add service-port 2
huawei(config-btv)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp multicast-vlan member service-port 1
huawei(config-mvlan1000)#igmp multicast-vlan member service-port 2
huawei(config-mvlan1000)#quit
9. Save the data.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1133
To Next Page
Loading...
Need help?
General
