14 FTTM Configuration (Base Station
Access)
About This Chapter
On a FTTM (base station access) network, 2G or 3G/4G base stations are connected to ONUs
that serve as cell backhaul units (CBUs) in multiple modes. Then the ONUs transmit 2G or 3G
services to OLTs and then to the upper-layer network. After being transmitted over the upper-
layer network, the services access the basic station controller (BSC) or radio network controller
(RNC). In this manner, 2G or 3G services are carried on the base station access network.
14.1 Overview of Base Station Access Service
Before configuring the base station access service, acquire the following basic knowledge.
14.2 Prinpicle of Planning Data for Base Station Access Service
This topic plans base station access service in a unified manner from different dimensions. The
data plans are used to guide configuration and optimization of base station access service in
different scenarios.
14.3 Configuring Base station access Clock Synchronization
This topic describes the concept and principle of clock synchronization in bse station access
network, clock synchronization solutions supported by devices, and configuration differences.
14.4 Configuring Base Station Access Service (GPON)
This topic describes how to configure the base station access service in GPON mode in different
networking scenarios.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1360
To Next Page
Loading...
Need help?
General
