Huawei SmartAX MA5608T User Manual

Configur
ation
Object
Step Description
DSLAM
(master
subrack)
Add a GE remote
extended subrack.
The operation of adding a GE remote extended subrack
to the master subrack is the same as that of adding a
service board to the master subrack. The GE remote
extended subrack can be automatically discovered or
deployed in offline mode.
After the extended subrack is added, the master subrack
manages it as a service board.
GE remote
extended
subrack
(configure
d through
the master
subrack)
Configure a VDSL2
port.
Configure a VDSL2+ profile and bind it to the VDSL2
port. Then, activate the VDSL2 port for service
transmission.
Configure a VDSL2
service flow.
In HGW networking, a VDSL2 service flow is of the
multi-service over multi-PVC type, which facilitates the
management and maintenance of various services.
(Optional)
Configure
vectoring.
The vectoring function enabled on a VDSL2 line can
greatly cancel the far-end crosstalk (FEXT) on the line
and increase the VDSL2 line rate.
Configure link
aggregation,
congestion control,
and security
policies.
The global configuration of link aggregation and
upstream queue scheduling based on priorities ensures
service reliability. The global configuration of security
policies ensures service security.
HGW Configure the
Internet access
service.
Refer to service configurations on the HGW on the
network where services are transmitted upstream
through DSL lines.
Configure the IPTV
service.
Configure the voice
service.
GE remote
extended
subrack
(configure
d through
the master
subrack)
HGW
Verify the
configured services.
PPPoE dialup, call, and multicast service emulation tests
can be performed on the master subrack for the services
on the GE remote extended subrack. This allows
commissioning and configuration engineers to remotely
verify services.
VoD and HGW voice service do not support remote
verification.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1047

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE