Prerequisites
The master subrack and upper-layer devices have been connected correctly, and the BRAS has
been configured.
Context
The following table lists the remote verification methods for different services.
NOTE
The VoD service and voice service on HGWs do no support remote service verification.
Remote
Verificati
on
Method
Function Remarks
PPPoE
dialup
emulation
Emulates PPPoE user terminal to
perform dialup and interact with the
BRAS to verify the connectivity
between the access device and BRAS.
l PPPoE dialup emulation requires a
service flow which does not
belong to a QinQ VLAN.
l A user name, password, and
authentication mode must be
configured on the BRAS for the
PPPoE dialup emulation.
l A GE remote extended subrack
supports a maximum of one
PPPoE dialup emulation at the
same time.
Multicast
emulation
Emulates a multicast user going online
and leads the program stream to an
access device. You can check whether
the multicast service is normal by
checking the real-time traffic of the
multicast program.
Multicast services configured in the
dynamic controllable multicast mode
do not support this function.
Data Plan
Item Data Remarks
PPPoE
dialup
emulation
parameters
Referenced service flow ID: 101
Emulation timeout time: 10s
The user name, password, and
authentication mode for the emulation
test must be configured on the BRAS
and must be the same as those planned
for the BRAS.
Multicast
emulation
parameters
Multicast service flow ID: 401
MVLAN: 1000
IP address of the multicast program:
224.1.1.10
-
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1070
To Next Page
Loading...
Need help?
General
