Huawei SmartAX MA5608T User Manual

Create service flows. Set the service VLAN to 300, GEM port ID to 12, and user
VLAN to 3001. Use traffic profile ftto_voip.
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 1 gemport 12 multi-
service
user-vlan 3001 tag-transform translate inbound traffic-table name
ftto_voip outboun
d traffic-table name ftto_voip
huawei(config)#service-port vlan 300 gpon 0/1/0 ont 2 gemport 12 multi-
service
user-vlan 3001 tag-transform translate inbound traffic-table name
ftto_voip outboun
d traffic-table name ftto_voip
3. Enable the ARP proxy function.
Voice media streams for different users of the same S-VLAN fail to interchange
because the service ports of the smart VLAN are isolated from each other. Therefore,
the ARP proxy function needs to be enabled on the OLT.
huawei(config)#arp proxy enable
huawei(config)#interface vlanif 300
huawei(config-if-vlanif300)#arp proxy enable
huawei(config-if-vlanif300)#quit
4. Save the data.
huawei(config)#save
l Configure the ONU on the Web page.
1. Log in to the Web configuration window.
a. Configure the IP address of the PC network adapter to be in the same network
segment as the IP address of the local maintenance Ethernet port on the ONU
(default: 192.168.100.1).
b. Open the Web browser, and enter the IP address of the local maintenance Ethernet
port of the ONU.
c. On the login window, enter the user name (default: telecomadmin) and password
(default: admintelecom) of the administrator. After the password authentication
is passed, the Web configuration interface is displayed.
2. Configure parameters of a voice WAN port.
a. In the navigation tree, choose WAN > WAN Configuration.
b. In the right pane, click New. In the dialog box that is displayed, configure
parameters of a WAN port as follows:
– WAN Connection: Enable
– Service List: VoIP (For configuring the VoIP service, VoIP or a combination
containing VoIP needs to be selected.)
– Mode: Route
– VLAN ID: 300 (The VLAN ID of the ONU must be the same as the user-side
VLAN ID configured on the OLT.)
– 802.1p: 5
– IP Acquisition Mode: DHCP
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1110

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE