Huawei SmartAX MA5608T User Manual

– VLAN ID: 300 (The VLAN ID of the ONU must be the same as the user-side
VLAN ID configured on the OLT.)
– 802.1p: 5
– IP Acquisition Mode: DHCP
c. Click Apply to apply the configuration.
3. Configure the parameters of the H.248-based voice interface.
a. In the navigation tree, choose Voice > VoIP Basic Configuration.
b. In the right pane, configure the parameters of the H.248-based voice interface as
follows (other parameters use the default settings):
– Set MGC Address below Primary Server to 200.200.200.200.
– MID Format: DomainName
– MG Domain: 6877687714852901
– Signaling Port: 1_VOIP_R_VID_300
– Region: China
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1155

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE