Security policies cover system security, user security, and service security, which ensure normal
running of services.
NOTE
Enable security features based on service types. For details, see 13.2.5 Principle of Security Data Plan.
Procedure
l Configure queue scheduling.
Based on 13.2.3 Principle of QoS Data Plan, all packets use strict priorities for queue
scheduling and are mapped to queues based on priorities.
huawei(config)#queue-scheduler strict-priority
huawei(config)#cos-queue-map cos0 0 cos1 1 cos2 2 cos3 3 cos4 4 cos5 5 cos6 6
cos7 7 //System default
l Configure system security.
– Enable deny of service (DoS) anti-attack on both the OLT and optical network units
(ONUs).
1. Run the security anti-dos enable command to globally enable DoS anti-attack.
2. Run the security anti-dos control-packet policy command to configure a
protocol packet processing policy that will be used when a DoS attack occurs.
3. Run the security anti-dos control-packet rate command to configure the
threshold for the rate of sending protocol packets to the CPU.
– Enable IP address anti-attack on both the OLT and ONUs.
Run the security anti-ipattack enable command to enable IP address anti-attack.
l Configure user security.
– Enable MAC address anti-flapping on both the OLT and ONUs.
Run the security anti-macduplicate enable command to enable MAC address anti-
flapping.
– Enable MAC address anti-spoofing on both the OLT and ONUs.
1. In global config mode, run the security anti-macspoofing enable command to
globally enable MAC address anti-spoofing.
2. Enable MAC address anti-spoofing at VLAN level in global config mode or
service profile mode:
a. In global config mode, run the security anti-macspoofing vlan command
to enable MAC address anti-spoofing.
b. Perform the following operations to enable MAC address anti-spoofing in
service profile mode:
a. In global config mode, run the vlan service-profile command to create
a VLAN service profile.
b. Run the security anti-macspoofing enable command to enable MAC
address anti-spoofing at VLAN level.
c. Run the commit command to make the profile configuration take
effect.
d. Run the quit command to quit the VLAN service profile mode.
e. Run the vlan bind service-profile command to bind the created VLAN
service profile to a VLAN.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1459
To Next Page
Loading...
Need help?
General
