Figure 16-5 Configuration roadmap for the home service networking
NOTE
Before logging in to the MA5633 to configure services on it, ensure that the MA5633 has been properly
connected.
The following table describes the configuration steps.
Config
uration
Object
Step Description
OLT
l IPv4: Configure Dynamic
Host Configuration Protocol
(DHCP) relay.
l IPv6: Configure Dynamic
Host Configuration Protocol
(DHCP) relay (IPv6).
This section describes how to configure
Dynamic Host Configuration Protocol
(DHCP) relay so that cable modems (CMs)
can obtain IP addresses in different network
segments.
l IPv4: Configure a route.
l IPv6: Configure a route
(IPv6).
This section describes how to implement
network communication by configuring a
route in Layer 3 networking with an optical
line terminal (OLT). Through the route,
packets are forwarded at Layer 3 between the
OLT and its upper-layer devices or servers.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1681
To Next Page
Loading...
Need help?
General
