NOTE
Before logging in to the MA5633 to configure services on it, ensure that the MA5633 has been properly
connected.
The following table describes the configuration steps.
Configur
ation
Object
Step Description
Optical line
terminal
(OLT)
l IPv4: Configure Dynamic Host
Configuration Protocol (DHCP)
relay.
l IPv6: Configure Dynamic Host
Configuration Protocol (DHCP)
relay (IPv6).
This section describes how to
configure Dynamic Host
Configuration Protocol (DHCP)
relay so that cable modems (CMs)
can obtain IP addresses in different
network segments.
l IPv4: Configure a route.
l IPv6: Configure a route (IPv6).
This section describes how to
implement network communication
by configuring a route in Layer 3
networking with an optical line
terminal (OLT). Through the route,
packets are forwarded at Layer 3
between the OLT and its upper-layer
devices or servers.
Add a D-CMTS to the OLT. You can configure a distributed cable
modem termination system (D-
CMTS) only after adding it to an
optical line terminal (OLT).
Configure a management channel
between the OLT and the D-CMTS.
This section describes how to
configure a management channel
between an optical line terminal
(OLT) and a distributed cable
modem termination system (D-
CMTS). After the configuration, you
can log in to the D-CMTS from the
OLT and configure the D-CMTS.
Configure a service channel between
the OLT and the D-CMTS.
This section describes how to
configure a service channel between
an optical line terminal (OLT) and a
distributed cable modem termination
system (D-CMTS). After the
configuration, the service channel
forwards service packets on the D-
CMTS based on the planned VLAN
and forwarding policy.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1735
To Next Page
Loading...
Need help?
General
