Huawei SmartAX MA5608T User Manual

Configure the VoIP
service (H.248/SIP)
Configure the Internet
access service
Verify the Internet access service,
VoIP service and IPTV services
ONU
Configure the IPTV
service
Configure the Internet
access service
Configure the IPTV
service
HGW
Add an ONU on the OLT
Configure the service channel
between the OLT and the ONU
Configure the management channel
between the OLT and the ONU
Start
Configure the link aggregation,
congestion control, and security policy
OLT
End
(Optional) Configure
Vectoring
NOTE
Texts in blue show the configuration (on OLT and ONU ) difference between IPv6 and IPv4.
For differences between the HGW's IPv6 and IPv4 service processing, see documentation of the HGW
products.
FTTB+HGW (HGW provides the voice service) Configuration Procedure
The following figure shows the IPv6 service configuration procedure in the FTTB+HGW (ONU
provides the voice service) scenario. In this scenario, the planning and configuration procedure/
method for IPv6 and IPv4 services are almost the same except the following differences. On the
OLT side: Multicast service channels between the OLT and ONU and part configuration
commands of the safety policy are different. On the ONU side: Configuration commands of
IPTV multicast services are different. 19.2 Configuration Difference Between IPv6 and
IPv4 shows the differences.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1903

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE