Huawei SmartAX MA5608T - Page 270

Figure 2-3 Example network of the HWTACACS authentication
Procedure
Step 1 Configure an authentication scheme.
Configure authentication scheme named newscheme (users are authenticated through
HWTACACS).
huawei(config)#aaa
huawei(config-aaa)#authentication-scheme newscheme
huawei(config-aaa-authen-newscheme)#authentication-mode hwtacacs
huawei(config-aaa-authen-newscheme)#quit
Step 2 Configure an authorization scheme.
Configure authorization scheme named newscheme (users are authorized through
HWTACACS).
huawei(config-aaa)#authorization-scheme newscheme
huawei(config-aaa-author-newscheme)#authorization-mode hwtacacs
huawei(config-aaa-author-newscheme)#quit
Step 3 Configure the accounting scheme.
Configure accounting scheme named newscheme (users are authenticated through
HWTACACS). the interval is 10 minutes.
huawei(config-aaa)#accounting-scheme newscheme
huawei(config-aaa-accounting-newscheme)#accounting-mode hwtacacs
huawei(config-aaa-accounting-newscheme)#accounting interim interval 10
huawei(config-aaa-accounting-newscheme)#quit
huawei(config-aaa)#quit
Step 4 Configure the HWTACACS protocol.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
2 Basic Configurations
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
245