Huawei SmartAX MA5608T User Manual

huawei(config)#save
----End
Result
After the interface data and the PSTN user data corresponding to the SIP interface are configured
on the IMS, check whether the VoIP services can be provisioned normally. In the normal state,
users of Phone 0-Phone 127 can communicate with each other successfully.
l The calling party can hear the dialing tone after picking up the phone.
l When the calling party dials the phone number of the called party, the phone of the called
party can ring normally, and the calling party can hear the ring-back tone.
l The calling party and the called party can communicate in the normal state.
l After the called party hooks on, the calling party can hear the busy tone.
Configuration File
The following describes the configuration file of this configuration example. Note that certain
steps must be performed manually and the configuration file cannot be imported directly.
Configure the upstream VLAN interface.
vlan 20 standard
port vlan 20 0/19 0
interface vlanif 20
ip address 10.10.10.10 24
quit
Configure the media and signaling IP address pools.
voip
ip address media 10.10.10.10 10.10.10.1
ip address signaling 10.10.10.10
Add an SIP interface and configure the attributes of the SIP interface.
if-sip attribute basic media-ip 10.10.10.10
signal-ip 10.10.10.10 signal-port 5060 transfer udp primary-proxy-ip1 10.10.10.20
primary-proxy-port 5060 home-domain huawei sipprofile-index 1
Configure the ringing mapping of the SIP interface.
ringmode add 0 ringname cadencering 0 initialring 4
Enable the SIP interface.
reset
quit
Query the running status of the SIP interface.
display if-sip all
Confirm the service board.
board confirm 0/2
board confirm 0/3
Configure the PSTN user data.
esl user
sippstnuser batadd 0/2/00/2/63 0 telno 83110000
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3 Configuring the DSLAM Services
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
322

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE