1. Configure the SHDSL line profile.
To configure the SHDSL line profile, run the shdsl line-profile add or shdsl line-profile
quickadd command.
huawei(config)#shdsl line-profile quickadd 10 line two-wire rate 2048 2048 psd
symmetric transmission Annex-A remote disable probe disable snr-margin ds-
curr 10 ds-worst
10 us-curr 10 us-worst 10 bitmap 0x03
2. Configure the SHDSL alarm profile.
To configure the SHDSL alarm profile, run the shdsl alarm-profile add command.
In this example, the default profile (profile 1) is used.
3. Configure the SHDSL traffic profile.
To configure the SHDSL traffic profile, run the traffic table ip command.
In this example, the default profile (profile 6) is used.
4. Activate the SHDSL port.
huawei(config)#interface shl 0/5
huawei(config-if-shdsl-0/5)#deactivate all
huawei(config-if-shdsl-0/5)#alarm-config all 1
huawei(config-if-shdsl-0/5)#activate all 10
huawei(config-if-shdsl-0/5)#quit
5. Configure the upstream port.
The SHDSL users of MA5600T-3 use the PPPoE authentication. In this case, the smart
VLAN is used to identify the users.
huawei(config)#vlan 3030 smart
huawei(config)#port vlan 3030 0/19 0-1
It will take several minutes, and console may be timeout, please use
command
idle-timeout to set time
limit
Are you sure to add standard port(s)? (y/n)[n]:y
6. Add the service port.
l Ports 0-15 of SHDSL board 0/5 provide the SHDSL service.
l To add service ports in batches, run the multi-service-port command.
huawei(config)#multi-service-port vlan 3030 port 0/5 0-15 vpi 0 vci 35 user-
encap
pppoe rx-cttr 6 tx-cttr 6
Step 8 Configure the GPON service.
1. Configure the service VLAN and the upstream port.
huawei(config)#vlan 1530 smart
huawei(config)#port vlan 1530 0/19 0
2. Configure the DBA profile.
huawei(config)#tcont-profile add profile-id 10 type1 fix 102400
3. Configure the alarm threshold profile.
l When you need to configure the alarm threshold value to monitor the performance
statistics of the activated ONT line, run the gpon alarm-profile add command to
configure the GPON alarm threshold profile.
l In the default GPON alarm threshold profile 1, all alarm thresholds are set to 0, which
indicates that no alarm is reported.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7 Example: Subtending Networking
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
534
To Next Page
Loading...
Need help?
General
