huawei(config)#voip
huawei(config-voip)#ip address media 10.176.6.33 10.176.6.62
huawei(config-voip)#ip address signaling 10.176.6.33
4. Configure the MG interface.
Add an MG interface.
huawei(config)#interface h248 0
Are you sure to add MG interface? (y/n)[n]:y
Configure the MG interface attributes.
huawei(config-if-h248-0)#if-h248 attribute mgip 10.176.6.33 mgport 2944 code
text
transfer udp mgcip_1 10.30.80.65 mgcport_1 2944 mg-media-ip 10.176.6.33
Configure the software parameters of the MG interface (in this example, only parameter
20 is configured, and other parameters use the default values).
huawei(config-if-h248-0)#mg-software parameter 20 2
5. Reset the MG interface.
NOTE
After configuring the MG interface, you need to reset the interface to validate the configuration.
huawei(config-if-h248-0)#reset coldstart
Are you sure to reset MG interface?(y/n)[n]:y
6. Add PSTN users in batches.
huawei(config)#esl user
huawei(config-esl-user)#mgpstnuser batadd 0/3/0 0/3/31 0 terminalid 0 telno
88660000
Step 10 Configure the multicast service.
After the configuration, the following results should be achieved:
l Users of port 0/2/2 need to be authenticated, and have rights to watch two programs and to
preview one program.
l Users of port 0/2 do not need to be authenticated.
1. Configure the xDSL.
In this example, it is unnecessary to configure the xDSL. The default line profile (profile
1002) is used.
2. Configure the VLAN.
l Create a smart VLAN.
huawei(config)#vlan 100 smart
l Set the VLAN upstream port.
huawei(config)#port vlan 100 0/19 0
l Configure the native VLAN.
huawei(config)#interface giu 0/19
huawei(config-if-giu-0/19)#native-vlan 0 vlan 100
l Create the traffic profile.
huawei(config)#traffic table ip index 8 cir off priority 5 priority-policy
tag-I
n-Packag
l Add ADSL2+ port 2 and 3 to VLAN 100.
huawei(config)#service-port vlan 100 adsl 0/2/2 vpi 0 vci 35 rx-cttr 8 tx-
cttr 8
huawei(config)#service-port vlan 100 adsl 0/2/3 vpi 0 vci 35 rx-cttr 8 tx-
cttr 8
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
7 Example: Subtending Networking
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
536
To Next Page
Loading...
Need help?
General
