Huawei SmartAX MA5608T User Manual

time, check whether the voice configuration on the MGC/SIP server is consistent
with that on the ONT.
– You can query the registration status of the voice service on the ONT web page.
If the query result shows that the registration fails or the voice service is in the
registering state for a long time, check whether the voice configuration on the
MGC/SIP server is consistent with that on the ONT.
l Verify the multicast service using multicast emulation.
1. Run the igmp static-join command to simulate a multicast user to order a multicast
program.
huawei(config)#btv
huawei(config-btv)#igmp static-join service-port 1 ip 224.1.1.10 vlan 1000
NOTE
If the multicast program is obtained dynamically, igmp static-join can be executed successfully
only when the range for obtaining the dynamic program is set.
2. Run the display igmp user command to query the status of the multicast user.
huawei(config-btv)#display igmp user service-port 1
User : 0/1/0/1
State : online
Authentication : no-auth
Quick leave : MAC-based
IGMP flow ID : 1
Video flow ID : 1
Log switch : enable
Bind profiles : -
IGMP version : IGMP v3
Current version : IGMP v3
Current IGMP IPv6 version : IGMP IPv6 v2
Available programs : 8
Global leave : disable
User max bandwidth : no-limit
Used bandwidth(kbps) : 0
Used bandwidth
to max bandwidth(%) : -
Total video bandwidth : -
Mcast video bandwidth : -
Active program list
-------------------------------------------------------------------------
--
Program name VLAN IP/MAC State Start time
-------------------------------------------------------------------------
--
PROGRAM-5 1000 224.1.1.10 watching 2011-10-29
16:33:41+08:00
-------------------------------------------------------------------------
--
Total: 1
3. Run the display multicast flow-statistic command to query the real-time traffic of
the multicast program.
huawei(config-btv)#display multicast flow-statistic vlan 1000 ip
224.1.1.10
{ <cr>|sourceip<K> }:
Command:
display multicast flow-statistic vlan 1000 ip 224.1.1.10
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
9 FTTH Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
709

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE