Item Data
NOTE
The data
configurati
on must be
the same as
the data
configurati
on on the
MGC.
paramet
ers
Media IP address and
signaling IP address
10.10.10.10/24
Default gateway IP address 10.10.10.1/24
MG interface ID 0
Signaling port ID 2944
IP address of the primary MGC 200.200.200.200/24
Port ID of the primary MGC 2944
Coding Text
Transmission mode UDP
H248 version that MG starts to
negotiate
1 (the negotiation starts from V1)
Voice user
configuratio
n data
Phone number 83110001-83110024
Terminal identification Terminal layering is not supported
and the terminal identification
ranges from 0 to 23.
User priority Cat2 for phone 1
Cat3 for phone 2 to phone 24
(default)
User type Common user (DEL user by default)
Common
parameter
System parameter Default value
Overseas parameter Default value
PSTN port attribute Polarity-reversal
Ringing current attribute Default value
Procedure
Step 1 Log in to and configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. The user name
is root and the password is mduadmin.
Step 2 Configure the upstream VLAN interface.
Specify the upstream VLAN interface for the media stream and the signaling flows and configure
the IP addresses of the Layer 3 interface. These IP addresses are the sources of the IP address
pools for the media stream and the signaling flows.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
870
To Next Page
Loading...
Need help?
General
