Intel S2600CP - Installing and Removing the Intel; Remote Management Module 4; Installing the Intel RMM4 Lite; Install the Intel RMM4 NIC

Hardware Installations and Upgrades
38 Intel
®
Server Board S2600CP Intel
®
Server System P4000CP Family Service Guide
Figure 59. Removing the Intel
®
RAID C600 Upgrade Key
Installing and Removing the Intel
®
Remote Management
Module 4
Installing the Intel
®
RMM4 Lite
Locate the RMM4 Lite connector next to RISER SLOT_1, carefully pickup the Intel
®
RMM4 Lite
module, match the alignment pin of the module and the connector on server board, then press to
install.
Figure 60. Installing the Intel
®
RMM4 Lite
Install the Intel
®
RMM4 NIC
1. Push out and remove the metal cover on the chassis where the NIC RJ-45 receptacle will align
(see letter “B”).
2. Connect the cable to the module (see letter “C”).
3. Secure the module to the cahsssi with the two screws (see letter “D”).