Intel S2600CP - Figure 129. USB Configuration Screen

Hardware Installations and Upgrades
120 Intel
®
Server Board S2600CP Intel
®
Server System P4000CP Family Service Guide
 A USB Key formatted as a CDROM drive will be recognized as an HDD.
 A USB Key formatted without a Partition Table will be forced to FDD emulation.
 A USB Key formatted with one Partition Table, and less than 528 MB in size, will be forced
to FDD emulation – otherwise if it is 528 MB or greater in size, it will be forced to HDD
emulation.
/
NOTE
USB devices cannot be “hotplugged” during POST – to be detected, they must be
inserted before the system is booted.
Figure 129. USB Configuration Screen
Advanced
USB Configuration
Detected USB Devices
<Total USB Devices in System>
USB Controller Enabled/Disabled
Legacy USB Support Enabled/Disabled/Auto
Port 60/64 Emulation Enabled/Disabled
Make USB Devices Non-Bootable Enabled/Disabled
USB Mass Storage Device Configuration
Device Reset timeout 10 seconds/20 seconds/30 seconds/40 seconds
Screen Field Descriptions:
1. Detected USB Devices
Option Values: <Number of USB devices detected in system>
Help Text: <None>
Comments: Information only
. Displays the total number of USB devices of all types
which have been detected in POST.
Back to [USB Configuration]