Intel S2600CP - Installing the Chassis Feet (Pedestal Configuration Only); Figure 105. Removing the Chassis Feet

Hardware Installations and Upgrades
Intel
®
Server Board S2600CP Intel
®
Server System P4000CP Family Service Guide (Preliminary) 65
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Loose the screws securing the rubber foott to the chassis and then remove the rubber foott from
chassis.
Figure 105. Removing the Chassis Feet
5. Repeat above steps until all four feet are removed.
Installing the Chassis Feet (Pedestal Configuration Only)
/
NOTE
Do not install feet on your Intel
®
Server Chassis P4000M family if it is to be installed in a
rack. Only install feet on a pedestal-configured chassis.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Lay the chassis down on its right side.
4. Insert rubber foot into chassis hole (see letter “A”).
5. Secure foot by inserting screw through the rubber foot (see letter “B”).
6. Repeat above steps until all four feet are installed.