SV-DA200 series AC servo drive Communication
-244-
32-bit fault code(16-bit Error
Code+16-bit additional message)
Encoder fault–EEPROM data check error
Current sensor fault–U phase IGBT fault
Current sensor fault–V phase IGBT fault
Current sensor fault–W phase IGBT fault
System initialization fault
Setting fault–Motor model error
Setting fault–Motor and drive model error
Setting fault–Software limit setting error
Setting fault–Homing mode setting fault
Setting fault–Position control overflow fault
Regeneration discharge overload fault
Analog input overvoltage fault–Analog input 2
Analog input overvoltage fault–Analog input 3
Analog input overvoltage fault–Analog input 3
EEPROM fault–Read-write fault
EEPROM fault–data check fault
Hardware fault–FPGA fault
Hardware fault–Communication card fault
Hardware fault–Grounding short circuit fault
Hardware fault–External input fault
Hardware fault–Emergency stop fault
Hardware fault–485 communication fault
Software fault-Motor control task re-entry
Software fault–Reentrant cycle mission
Software fault–Illegal operation
IO fault–Repeat digital input distribution
IO fault-Repetitive analog input distribution
IO fault–Pulse input frequency is too high
Main circuit overvoltage fault
Main circuit undervoltage fault
Undervoltage control power fault
Motor overtemperature fault
Speed fault–Overspeed fault
Speed fault-FWD overspeed fault
Speed fault-REV overspeed fault
Speed fault- Overspeed parameter setup error
To Next Page
Loading...
