SV-DA200 series AC servo drive Appendix
-292-
10.4 Fault code
The format of fault code is ErXX-X, of which, XX is the master code and X is the sub code.
Example: , the master code is 01, the sub code is 0. Other codes are displayed in
the similar way.
Brake tube fault (7.5kW and above model)
Encoder fault–The encoder wire break
Encoder fault–Encoder feedback error is too large
Encoder fault–Parity error
Encoder fault–Frame error
Encoder fault–A short frame error
Encoder fault–Encoder overtime
Encoder fault–FPGA overtime
Encoder fault–Low voltage alarm of the encoder
Encoder fault–Undervoltage alarm of the encoder
Encoder fault–Encoder over-temperature
Encoder fault–EEPROM write error
Encoder fault–EEPROM no data
Encoder fault–EEPROM data check error
Current sensor fault–U phase current sensor fault
Current sensor fault–V phase current sensor fault
Current sensor fault–W phase current sensor fault
System initialization fault
Setting fault–Motor model does not exist
Setting fault–Motor and drive model does not match
Setting fault–Software limit setting error
Setting fault–Homing mode setting fault
Setting fault–Bit control travel overflow fault
Regeneration discharge overload fault
Analog input overvoltage fault–Analog input 1
Analog input overvoltage fault–Analog input 2
Analog input overvoltage fault–Analog input 3
To Next Page
Loading...
