INVT SV-DA200 Series User Manual

SV-DA200 series AC servo drive Safety precautions
-II-
Safety precautions
Safety symbols:
The safety symbols are marked in the front or side of the servo drive. Users must follow these
safety instructions when operating on the servo drive.
Recycling symbol:
When the life cycle ends, the product should enter the recycling system. Dispose
of it separately at an appropriate collection point instead of placing it in the normal
waste stream.
Following safety precautions should be paid attention to before any installation, configuration,
operation, maintenance and inspection:
 Check whether the AC power supply is the same as the rated voltage of the servo drive, otherwise
fire, hurt, damage to the drive may occur.
 Do not connect the input power cables to the output terminals, otherwise damage to the drive may
occur.
 Do not carry out any insulation and voltage withstand test to the drive directly, and do not test the
control circuit of the drive by megameter.
 Connect the drive and motor as correct phase sequence, otherwise drive fault or damage may
occur.
 De-couple the motor load and run the motor independently before operation to avoid accidents.
 Please ensure the drive can be disconnected from the power supply by E-switch before any
operation.
 Set the corresponding parameters before operation, otherwise the drive may run abnormally or
beyond the expectation because of the load.
 Only qualified electrical engineers can carry out the wiring, otherwise electric shock or fire may
occur.
 Do not touch the conductive parts directly; do not connect any external cables (especially those

INVT SV-DA200 Series Specifications

General

Brand	INVT
Model	SV-DA200 Series
Category	Servo Drives
Language	English