KIP 3000 - Basic Scanning Operations; Simple Scanning Steps

Section 4 Scan Mode - Monochrome 4-3
1.2 Simple Scanning
To scan to file, please follow these basic steps.
The following chapters have details on adjustments and parameters that the user can
change to modify the scans.
1.2.1 Select Scan Mode
On the lower region of the UI, select “SCAN”.
1.2.2 Select Size Mode
Select whether the document is an engineering or architectural size document. This will
allow the automatic width detection to function.
Engineering widths = 34, 22, 17, 11, and 8.5 inches
Architecture widths = 36, 30, 24, 18, 12, and 9 inches