KIP 3000 - Select Original Image Type; Select Scan Mode; Select Size Mode; Simple Scanning

Section 5 Scan Mode - Color 5-3
1.2 Simple Scanning
To scan to file in color, please follow these basic steps. The following chapters have
details on adjustments and parameters that the user can change to modify color scans.
1.2.1 Select Scan Mode
On the lower region of the UI, select “SCAN” then select Color Mode in the upper left
corner.
1.2.2 Select Size Mode
Select whether the document is an engineering or architectural size document. This will
allow the automatic width detection to function.
Engineering widths = 34, 22, 17, 11, and 8.5 inches
Architecture widths = 36, 30, 24, 18, 12, and 9 inches
1.2.3 Select Original Image Type
Set the original Image type you will scan. The selections are:
Line - used for simple color line documents
Line / Photo - used for a combination of color lines & photos
Photo - used for color photographic originals