Section 1 Basic Printer Functions 1-15
2.1 Turning on the KIP 3000
1. Ensure the KIP 3000 is plugged into a dedicated
wall outlet.
2. There is a Power Switch on the right side of
KIP3000.
Switch to the “ I ” position to turn on the KIP3000.
Power Switch
3. The Operation Panel commences to operate, and the Copy Mode Screen will appear in
approximately 1 minute. A Ready Indicator on the Copy Mode Screen will flash during the
warm up process.
Ready Indicator
4. When the Ready Indicator stops flashing, the KIP 3000 is ready to copy/scan/print.
WARNING
(1) Do not handle the Power Plug with wet hands, or you may receive an electrical shock.
(2) Make sure to ground the machine for your safety.
(3) Do not plug the printer into a multi-plug connector in which other devices are
plugged into. It may overheat the outlet and may result in a fire.
(4) The outlet must comply with 120V, plus 6% & minus 10%, 15A, and 50/60Hz
To Next Page
Loading...
