MACHINE OPERATIONS AND CONTROLS OPERATION
3-232
4. Set lock lever (3) to LOCK position (L).
CHECK BEFORE SHUT OFF ENGINE 3
Check on the machine monitor display the engine coolant and
oil temperatures, hydraulic oil temperature, PTO oil tempera-
ture, engine hydraulic pressure and remaining fuel amount.
If an abnormality is found in any of them, take proper action
after stopping the engine and in reference to “TROUBLES AND
ACTIONS (3-240)“.
MACHINE INSPECTION AFTER DAILY WORK 3
1. Walk around the machine and check the work equipment, machine exterior, and undercarriage, also check for
any leakage of oil or coolant. If any problems are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard.
4. Remove any mud affixed to the undercarriage.
To Next Page
Loading...
