EasyManua.ls Logo

Komatsu PC2000-8 - Discharged Battery; Battery Removal and Installation

Komatsu PC2000-8
504 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TROUBLES AND ACTIONS OPERATION
3-242
DISCHARGED BATTERY 3
WARNING
q It is dangerous to charge a battery when installed on a
machine. Make sure that it is removed before charging.
q When checking or handling the battery, stop the
engine and turn the starting switch key to the OFF
position.
q The battery generates hydrogen gas, so there is a haz-
ard of explosion. Do not bring lighted cigarettes near
the battery, or do anything that will cause sparks.
q Battery electrolyte is dilute sulfuric acid, and it will
attack your clothes and skin. If it gets on your clothes
or on your skin, immediately wash it off with a large
amount of water. If it gets in your eyes, wash it out with
fresh water and consult a doctor.
q When handling batteries, always wear safety glasses
and rubber gloves.
q When removing the battery, first disconnect the cable
from the ground (normally the negative (-) terminal).
When installing, install the positive (+) terminal first.
If a tool touches the positive terminal and the chassis,
there is danger that it will cause a spark, so be
extremely careful.
q If the terminals are loose, there is danger that the
defective contact may generate sparks that will cause
an explosion.
q When removing or installing the terminals, check
which is the positive (+) terminal and which is the neg-
ative (-) terminal.
Battery Removal and Installation 3
q Before removing the battery, remove the ground cable (normally connected to the negative (-) terminal).
If any tool touches between the positive terminal and the chassis, there is a hazard of sparks being generated.
q When installing the battery, connect the ground cable last.
q When replacing the battery, fix the battery securely in position with the battery mounting clamp.
Tightening torque of mounting bolt: 9.8 to 19.6 Nm (1.0 to 2.0 kgm)
q For machines equipped with the optional battery isolator switch, turn the starting switch OFF before removing
or replacing the battery, then wait for at least 3 minutes before turning the battery isolator switch OFF.

Table of Contents

Related product manuals