ATTACHMENTS AND OPTIONS HANDLING SERVICE CENTER
6-21
3. Set drain valve (P) of the oil pan to open position (O).
4. Remove the cap of engine oil coupler (1) and connect the
force-feed pump coupler securely.
5. Start to drain and add engine oil.
6. After completing the draining and adding of engine oil,
remove the force-feed pump coupler.
7. Install the cap to the coupler.
8. Set drain valve (P) of the oil pan to shut position (S).
9. Run the engine for a short time at low idling, then stop the
engine. Check that the oil level gauge (G) is between the
H and L marks. For details, see “Check Oil Level in
Engine Oil Pan, Add Oil (3-163)“.
10. After checking, install oil filler port (F).
To Next Page
Loading...
