Network printing
4
IC-206 4-27
After changing the settings for parameters marked with an asterisk (
*
), turn
the machine off, then on again.
Specifying the NetWare 4.x/5.x/6 remote printer mode settings
1 Log on with Administrator privileges.
2 Start up NWadmin.
3 Select the organization performing the print service or the category
container, and then select "Print service quick setup" from the "Tools"
menu.
4 Type in the print server name, printer name, print queue name and
volume name, select "Remote parallel, LTP1" as the printer type, and
then save the specified settings.
– For queue user privileges, the printer notification option,
assignment of multiple queues, and passwords, refer to the
NetWare documentation, and specify settings as necessary.
5 Start up PageScope Web Connection, click the Network tab in
Administrator mode, select "NetWare Configuration", and then specify
the following settings for the copier.
– For details on using PageScope Web Connection, refer to "Using
PageScope Web Connection" on page 12-3.
6 From the NetWare Server console, load PSERVER.NLM.
7 From the NetWare Server console, display the printer server screen,
and check that the printer name entered in step4 is displayed for
Printer0 and that it is listed as "waiting for job".
Password Retype Specify only when setting from the NetWare Server.
Preferred File Server Not necessary to specify Name of the file server that
connects to PServer
Preferred NDS Tree Name of the tree where Pserv-
er logs on
Not necessary to specify
Print Queue Scan Rate
*
1 (Change as necessary.)
Mode
*
Pserver
Printer Number 1 (Change according to the setting.)
Connection Mode Directory Services Bindery
Parameter NDS Bindery
To Next Page