Network settings
8
IC-206 8-29
Specifying the e-mail address of the sender
1 In the "E-MAIL SETTING 1" menu, press the [,] or [+] key until "E-MAIL
ADDRESS" is selected, and then press the [OK] key.
2 Type in the e-mail address of the sender.
– The e-mail address can contain a maximum of 64 characters.
– If this machine will not be used to receive e-mail messages, enter
the e-mail address of the administrator.
– Be sure to first obtain from the network administrator the e-mail
address to be registered with the machine.
3 Press the [OK] key.
After the message "ACCEPTED" appears, the "E-MAIL SETTING 1"
menu appears again.
2
Note
If a number was incorrectly entered, press the [Clear/Stop] key to erase
the number, and then type it in correctly.
E-MAIL SETTING 1
E-MAIL ADDRESS
SENDER NAME
SMTP SERVER ADDR.
E-MAIL ADDRESS
:163@test.local
To Next Page
Loading...
