Konica Minolta IC-206 - Installing Using the Add Printer Wizard on Windows Vista

Installing the printer driver
3
IC-206 3-21
Installing using the Add Printer Wizard on Windows Vista
2
Note
When using a USB cable to connect this machine to the computer, turn
off this machine, and then install the printer driver. When the machine is
turned on, Plug and Play causes the Found New Hardware wizard to
appear.
1 After Windows has started, insert the printer driver CD-ROM into the
CD-ROM/DVD drive of the computer.
2 Click the [Start] button, and then click "Control Panel".
3 Click "Hardware and Sound", then "Printer".
– If Control Panel is displayed in the classic view, double-click
"Printers".
The Printers window appears.
4 Click "Add a printer" in the toolbar.
"Add Printer" dialog box appears.
5 Click "Add a local printer".
"Choose a printer port" dialog box appears.
6 Select "LPT1: (Printer Port)" of "Use an existing port", and then click
the [Next] button.
– In order to print on a network, the connection port must be set up
as a network port. Since the port settings can be specified after
installation, this procedure describes how to install the printer driver
for a local connection. For details on specifying the port settings,
refer to "Connecting the computer and this machine over a
network" on page 4-18.
7 Click the [Have Disk] button.
8 Click the [Browse] button, select "\Driver\WinVista\English" on the
CDROM, and then click the [Open] button.
– With 64-bit operating systems, select "\Driver\WinVista64\English".
9 Click the [Open] button again.