Installing the printer driver
3
IC-206 3-11
Installing using Plug and Play on Windows Vista
2
Note
If the driver is installed using Plug and Play, first the TWAIN driver for
scanning is installed, and then installation of the printer driver begins. The
procedure described in this manual is for the installation of the TWAIN
driver, then the printer driver. For details on the TWAIN river, refer to the
user manual for the TWAIN driver.
Follow the instructions that appear in the Found New Hardware wizard to
complete the installation.
1 In the Found New Hardware wizard, select "Locate and install driver
software (recommended)".
– If the User Account Control dialog box appears, click the [Continue]
button.
– If a message appears, requesting confirmation to search online,
click the [Don’t search online] button.
2 In the dialog box for checking the disk, click the [I don’t have the disk.
Show me other options.] button.
3 Insert the printer driver CD into the CD-ROM/DVD drive of the
computer.
4 Click the [Browse my computer for driver software (advanced)] button.
5 Select "Include subfolders", and then specify the following folder on
the CD-ROM as the location where the driver is saved.
– Folder to be specified: \Driver\WinVista\English
– With 64-bit operating systems, select "\Driver\WinVista64\English".
– The folder can be selected after clicking the [Browse] button.
6 Click the [Next] button.
– In the Windows Security dialog box, select "Install this driver
software anyway".
7 After the installation is finished, click the [Close] button.
This completes the installation of the TWAIN driver.
The Found New Hardware wizard appears again, and the installation of
the printer driver begins.
8 Repeat steps 2 through 7 to install the printer driver.
To Next Page
Loading...
