3
Installing the printer driver
3-10 IC-206
Installing using Plug and Play on Windows XP/Server 2003
2
Note
If the driver is installed using Plug and Play, first the TWAIN driver for
scanning is installed, and then installation of the printer driver begins. The
procedure described in this manual is for the installation of the TWAIN
driver, then the printer driver. For details on the TWAIN driver, refer to the
user manual for the TWAIN driver.
2
Note
When using Windows XP (Service Pack 2), a dialog box may appear,
requesting confirmation to connect to Windows Update. At this time,
select "NO", and then click the [Next] button.
Follow the instructions that appear in the Found New Hardware Wizard to
complete the installation.
1 Select "Install from a list or specific location [Advanced]", and then
click the [Next] button.
2 Select "Include this location in the search:" and then specify the
following folder on the CD-ROM as the location where the driver is
saved.
– Folder to be specified: \Driver\WIN2K_XP\English
– With 64-bit operating systems, select "Driver\WinXP64\English".
– The folder can be selected after clicking the [Browse] button.
3 Click the [Next] button.
– When the Windows logo testing warning message appears, click
the [Continue Anyway] button.
The Completing Found New Hardware Wizard dialog box appears.
4 Click the [Finish] button.
This completes the installation of the TWAIN driver.
The Found New Hardware Wizard appears again, and the installation
of the printer driver begins.
5 Repeat steps 1 through 4 to install the printer driver.
To Next Page