4
Network printing
4-12 IC-206
4.3 Specifying an IP address
The following procedure describes how to assign the IP address to the
machine from the control panel.
2
Note
The IP address setting should be specified according to instructions from
the network administrator.
The IP address setting is specified in Utility mode by the administrator.
1 Press the [Utility] key in the control panel.
2 Press the [,] or [+] key until "ADMIN. MANAGEMENT" is selected, and
then press the [OK] key.
UTILITY MODE
ADMIN. MANAGEMENT
USER MANAGEMENT
COPY SETTING 1
To Next Page
Loading...
