BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b340.fm 3-67
Operation
Removing a standard bucket from the quickhitch
In order to prevent the attachment from tipping over, place it on the ground
ensuring stability!
☞ Position the attachment so that after unlocking it will stand
safely and not tip over
☞ Remove the bucket as follows:
• Drive the machine to the drop-off position with an empty attachment
• Tilt in the quickhitch. To do this: push the control lever to the left A
• Lower the loader unit until the attachment is about 5 – 10 cm above the ground. To do
this: push the control lever forwards C
• Unlock the 3rd control circuit –seeOperating and securing the 3rd control circuit on
page 3-63
• Push and hold switch 101 on the control lever to the left A until the attachment is
unlocked
• Tilt the quickhitch slightly forwards. To do this: push the control lever to the right B
• Lower the loader unit. To do this: push the control lever to the front C until the
attachment is on the ground without risking falling over
• Reverse the machine away from the attachment
Fig. 107: Lowering and tilting in the attachment
C
D
A
F
E
Fig. 108: Changing over hydraulic connections
A
B
C
D
B
101
To Next Page
Loading...
