BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b330.fm 3-27
Operation
Bucket transport position
Loader unit operation
–seeLoader unit control lever (overview) on page 3-62
☞ Set the bucket to transport position as follows:
• Empty and tilt back the bucket B
• Raise the loader unit so that both red marks D on the lift frame and the bulkhead are
aligned
➥ Ground clearance C about 250 mm
• Cover the blade or teeth of the bucket across their entire width with the tooth guard A
provided
Remove buckets/attachments that are not authorised for transport on public
roads and use a suitable means of transport to move or transport them.
• – see chapter 1 “Attachments with authorised material densities” on
page 1-5
• Secure the control lever (joystick)
➥ –seeLocking the control lever (joystick) and the 3rd control circuit (attachments) on
page 3-29
C
A
B
C
Fig. 51: Transport position
To Next Page
Loading...
