2-6 BA 35101/02/03 EN – Edition 1.0 * Sicherheit_Radlader.fm
Safety instructions
2.4 Safety instructions regarding operation
Normal operation
• Avoid any operational mode that might be prejudicial to safety!
• Before beginning work, familiarise yourself with the surroundings and circumstances of
the work site. These are e.g. obstacles in the working and travelling area, the load-
bearing capacity of the ground and any necessary barriers separating the work site
from public roads!
• Take the necessary precautions to make sure the machine is used only when in a safe
and reliable state!
Operate the machine only if all protective and safety-oriented devices, e.g. removable
safety-devices, soundproofing elements and exhausters etc., are in place and fully
functional!
• Check the machine at least once a day/per work shift for visible damage and defects.
Report any changes (incl. changes in the machine's working behaviour) to the
competent organisation/person immediately! If necessary, stop the machine immedi-
ately and lock it!
• In the event of malfunctions, stop the machine immediately and lock it! Have any
defects rectified immediately!
• Start and operate the machine from the seat only!
• Before leaving the seat, apply the parking brake and stop the diesel engine!
• Carry out start-up and shut-down procedures in accordance with the Operator's
Manual, and observe the telltales!
• Before putting the machine/attachment into operation (start-up/moving), make sure
nobody is at risk by putting the machine/attachment into operation!
• Before driving with the machine, and also after interrupting work, check whether the
brakes, the steering, signalling and light systems are functional!
• Before moving the machine always check whether the supplementary equipment and
the attachments have been safely stowed away or attached!
• When driving on public roads, ways and places, observe the valid traffic regulations
and, if necessary, make sure beforehand that the machine is in a condition perfectly
compatible with these regulations!
• Always switch on the lights in conditions of poor visibility and after dark!
• No raising, lowering or carrying persons in the work equipment/attachments!
• Installing a man basket or a working platform is prohibited!
(Always contact Kramer-Werke GmbH for installation!)
• When crossing underpasses, bridges and tunnels, or when passing under overhead
lines always make sure there is enough clearance!
• Always keep at a safe distance from the edges of building pits and slopes!
• When working in buildings or in enclosed areas, look out for:
• Height of the ceiling/clearances
• Width of entrances
• Maximum load of ceilings and floors
• Sufficient room ventilation – danger of poisoning!
To Next Page
Loading...
