BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b340.fm 3-85
Operation
3.57 Fitting pallet forks
Picking up pallet forks with the quickhitch
The pallet forks are picked up and mounted on the quickhitch in the same way
as the standard bucket.
• –seeFitting a standard bucket onto the quickhitch on page 3-66
Before starting work, make sure the attachment is safely locked onto the quick-
hitch by means of the lock ram.
☞ You must be able to see the lock pins on either side (left/right) in the mount-
ing bores on the attachment!
Removing the pallet forks from the quickhitch
The pallet forks are removed from the quickhitch in the same way as the stand-
ard bucket.
• If the machine is equipped with pallet forks with foldable fork arms, fold
them down to the work position and secure them before they are removed
• –seeRemoving a standard bucket from the quickhitch on page 3-67
3.58 Driving on public roads with pallet forks
German road traffic regulations prohibit driving on public roads if the distance between the
front edge of the forks and the centre of the steering wheel is over 3500 mm in transport
position.
Only pallet forks with foldable fork arms are authorised for transport on public
roads.
➥ – see chapter 1 “Fields of application and using a wheel loader with an attachment” on
page 1-5
☞ If the machine is equipped with pallet forks with foldable fork arms (option), fold them
back and secure them
☞ Lower the pallet forks to transport position –seeBucket transport position on
page 3-27
Get informed on and follow the legal regulations of your country!
Fig. 138: Checking the lock pins
To Next Page
Loading...
