3-40 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b330.fm
Operation
3.28 Load stabiliser (option)
General instructions regarding the load stabiliser function
The load stabiliser cushions and dampens the movements of the loader unit. It avoids
unstable oscillating movements of the loader and increases drive comfort and safety!
Always switch on the load stabiliser when driving on public roads!
In order not to impair the load stabiliser function in transport position of the
loader unit, do not retract the tilt ram to the limit (pressure)!
• After setting the loader unit to transport position, dump in the bucket as far
as it will go, then dump it out slightly again
• Switch off the load stabiliser during pallet forks operation
• –seeSwitching the load stabiliser ON and OFF on page 3-41
If the machine is equipped with the “Hose burst valve” option, switching on
the load stabiliser automatically disables the hose burst valve, and the
hydraulic lines and pipes are no longer protected against possible damage!
☞ –see“Hose burst valve” safety feature (option) on page 3-98
☞ Switch off the load stabiliser during pallet forks operation
To Next Page
Loading...
