Kramer 380

2-10 BA 35101/02/03 EN – Edition 1.0 * Sicherheit_Radlader.fm
Safety instructions
2.5 Safety instructions for maintenance
• Avoid any operational mode that might be prejudicial to safety!
• Observe the adjustment, maintenance and inspection activities and intervals set forth in
the Operator's Manual, including information on the replacement of parts/partial
equipment!
These activities may be carried out by technical staff only!
• The machine may not be serviced, repaired or test-driven by unauthorised staff!
• Brief operating staff before beginning special operations and maintenance work!
Appoint a person to supervise the activities!
• In any work concerning the operation, conversion or adjustment of the machine and its
safety-oriented devices, or any work related to maintenance, inspection and repair,
observe the start-up and shut-down procedures set forth in the Operator's Manual, and
the information on maintenance work
• If required, secure the maintenance area appropriately!
• Prior to carrying out service, maintenance and repair work, attach a warning label, such
as “Repair work – do not start machine!”, to the ignition lock/steering wheel or to the
control elements.
Remove the ignition key!
• Carry out service, maintenance and repair work only if the
• machine is positioned on firm and level ground
• lever for selecting the driving direction is in neutral
• parking brake is applied
• all hydraulically movable attachments and working equipment have been lowered to
the ground
• engine is stopped
• ignition key is removed and the
• machine has been secured against unintentional movement!
• Should maintenance or repair be inevitable with the engine running:
• Only work in groups of two
• Both persons must be authorised for the operation of the machine
• One person must be seated on the seat and maintain visual contact with the other
person
• Observe the specific safety instructions in the work manual
• Keep a safe distance from all rotating and moving parts, e.g. fan blades, V-belt
drives, PTO shaft drives, fans etc.!
• Prior to carrying out assembly work on the machine, make sure no movable parts will
roll away or start moving!
• To avoid the risk of accidents, parts and large assemblies being moved for replacement
purposes must be carefully attached and secured to lifting gear.
Use only suitable lifting gear and suspension systems in a technically perfect state with
adequate load-bearing capacity!
Stay clear of suspended loads!
• The brake and steering systems are crucial to safety. Maintenance work must be
carried out by trained staff and an authorised workshop only!