BA 35101/02/ 03 EN – Edition 1.0 * Aggressive Medien.fm 5-41
Maintenance
Applying the protective anticorrosion coating
Bear in mind the following instructions as you apply the anticorrosive wax:
Carefully cover all fastening surfaces and elements to which the anticor-
rosive protection may not be applied –seeComponents coated with
anticorrosive wax on page 5-39
• ANTICORIT BW 366 can be applied with a brush, by means of immersion or with all
commercially available spray guns.
• ANTICORIT BW 366 protective coating can be removed with petrol, RENOCLEAN E/K
or FUCHS MULTICLEAN as required.
• ANTICORIT BW 366 spots are difficult to remove on clothing.
• Affix a “Wet paint!” or a similar sign to newly coated machines.
Treatment of oxidised surfaces
If in spite of all precautionary measures some components should be affected by corrosion
(oxidised), proceed as follows:
Electric connections
☞ Remove the remaining protective wax in the oxidised area with petrol, RENOCLEAN E/
K or FUCHS MULTICLEAN
☞ Treat the affected area with an oxide solvent, such as KONTAKT 60, and rinse it with
e.g. KONTAKT WL
☞ Treat the contact surfaces of the connection with e.g. KONTAKTSPRAY WD 40
☞ Establish the connection
☞ Apply/spray anticorrosion wax onto the electric connection from all sides
Sheet-metal parts
☞ Remove the remaining protective wax in the oxidised area with petrol, RENOCLEAN E/
K or FUCHS MULTICLEAN
☞ Remove all remaining corrosion and paint coating from the affected area down to the
bare material, otherwise the paint coating will not adhere properly!
☞ Clean the affected area with a cleaning solvent, and apply a 2-component prime coat-
ing and then a 2-component paint coating to it
☞ Then preserve the area with anticorrosion wax
To Next Page
Loading...
