BA 35101/02/ 03 EN – Edition 1.0 * Aggressive Medien.fm 5-39
Maintenance
5.20 Maintenance work “Aggressive Media” (option)
The machine is specially protected against corrosion for work in aggressive media (e.g. a
saline environment).
However, this anticorrosion protection is affected by external factors e.g. dirt, cleaning etc.
This is why it only has ongoing effect if checked at regular intervals and renewed or reap-
plied as required.
If no anticorrosion protection is applied to the machine, for instance for work in a saline
environment, we recommend retrofitting your machine with the “Aggressive Media” option
by a sales partner.
Anticorrosion protection applied in the factory
The following anticorrosive wax has been used in the factory:
Components coated with anticorrosive wax
Description: ANTICORIT BW 366
Manufacturer: FUCHS MINERALOELWERKE GMBH/Mannheim
Specification: TI 8030-015/K 19/MIL-C-16 173 C-Grade 4
Component Remarks
All electric plug-and-socket, earthing
and crimp connections
Before applying the wax:
• Apply contact spray to contact surfaces and
connect the plug and socket connections
again
• Apply a particularly thick anticorrosion layer
to the connecting parts of the fuel level trans-
mitter
All machine parts such as axles, gear-
box, trim panels, servicing lids, loader
unit, quickhitch
Except:
• Piston rods (chromium layer)
• Cab, cab bearings
• Engine cover, engine mounting
• Air filter
• Counterweight
• Fastening surfaces for mounting parts on
frame
• Radiator and insulating mats
• Mudguards, rubber and plastic parts
• Light elements
Flange surfaces
E.g. axles, engine and cab bearing:
• Seal gaps with anticorrosion wax after
assembly
Maintenance
To Next Page
Loading...
