3-34 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b330.fm
Operation
3.21 Accelerator pedal
Speed control with the accelerator pedal
☞ Accelerator pedal Fig. 30/16 controls the drive speed as follows:
• Press the accelerator pedal down
➥Drive speed is increased
• Release the accelerator pedal slowly
➥Drive speed is reduced
• Release the accelerator pedal fully
➥Hydrostatic braking
:
Maximum speed depends on the speed range selected.
• –seeSelecting a speed range on page 3-37
3.22 Accelerator pedal lock – manual throttle (option)
Disabling/enabling the accelerator pedal lock
This option is especially useful for operation of hydraulic attachments in order to ensure a
continuous hydraulic oil supply and/or drive speed.
The accelerator pedal lock is set by means of the accelerator pedal and tip switch 92 on
the switch panel on the right on th control lever base.
Use the accelerator pedal lock only during work operation.
Driving on public roads with the accelerator pedal lock (manual throttle) is not
allowed!
☞ See also the machine documentation and the data confirmation (Germany)
☞ Enabling the accelerator pedal lock:
• Select and hold the required engine or drive speed with the accelerator pedal
• Press tip switch 92 in the switch panel (1 x) and telltale 44 comes on
➥The required engine or drive speed is set
☞ Disabling the accelerator pedal lock:
• Press tip switch 92 in the switch panel (1 x), or switch 103 on the joystick (change of
direction)
➥The accelerator pedal lock is disabled and telltale 44 goes out
Fig. 59: Disabling/enabling the accelerator
pedal lock
103
92
44
To Next Page
Loading...
