3-18 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b330.fm
Operation
3.12 Battery master switch (option)
Battery master switch operation
Battery master switch A is located in the engine compartment at the upper left above the
variable displacement pump (drive)
☞ Interrupting power supply
• Turn and remove the key of the battery master switch (notched position)
☞ Switching on power supply
• Insert the key in the battery master switch
• Turn the key to the notched position
3.13 Key-based drive interlock (option)
Key-based drive interlock: scope of delivery
The drive interlock is integrated in the ignition lock and can be enabled only with the blue
ignition keys!
Scope of delivery:
• Drive interlock installed in the machine
• 2 x blue keys (coded)
• 1 x red master key (for training the blue keys)
Coding (“training”) new ignition keys
New personal keys are coded with the master key (red). This is why it must be carefully
stored outside the machine.
Each drive interlock has only one master key!
☞ The drive interlock must be replaced if the master key is lost
• The master key is only used for coding new keys, and cannot be used for disabling the
drive interlock
• Coding is carried out by inserting the master key in the ignition lock and by turning it to
position '1' for a maximum 5 seconds. After the master key has been returned to
position '0' and removed, you have 15 seconds for inserting a key that requires coding.
It must be inserted in the ignition lock and turned to position '1' in order to be registered
as a valid key.
• Coding is automatically stopped if no key requiring coding is detected within 15
seconds.
• Several keys requiring coding can be inserted one after another in the ignition lock
• Each key must remain at least 1 second in position '1'.
• Coding can be carried out for a maximum 10 keys
A
Fig. 47: Battery master switch
To Next Page
Loading...
