1-14 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b110.fm
Introduction
Labels inside the cab
Label: load diagram (A) for pallet forks and tyre pressure table
The framed weight indications state the maximum authorised load on the fork arms for
industrial and offroad applications.
The maximum load varies according to the distance between the load centre and the rear
end of the pallet forks.
Example on how to read the load diagram – see chapter 3 “Load diagram for pallet forks”
on page 3-89
The load diagram is valid only for applications with pallet forks!
• –seeAttachments with authorised material densities on page 1-5.
Observe the specific loads of other attachments used, e.g. rotary crane jib.
Label (B): tyre pressure table
List of authorised types of tyres with prescribed tyre inflation pressures.
➥– see chapter 6 “Tyres” on page 6-11
Location
Inside the cab, on left side of front window
Label: control lever (joystick) operation
• A = driving direction: (F) forwards (R) reverse and (N) neutral position
• B = additional control circuit with additional functions (option)
• C = automatic bucket repositioning (option) or front socket power supply
• D = locking/unlocking an attachment fitted on the quickhitch
• E = differential lock
• F = 4th control circuit (option)
• G = loader unit control pattern: raise/lower and dump in/out (optional float position)
Location
On the right-hand side window next to the control lever (joystick)
A
C
G
Fig. 18: Control lever label
E
DB
F
To Next Page
Loading...
