3-70 BA 35101/02/03 EN – Edition 1.0 * 35101_02_03b340.fm
Operation
Safety instructions for transporting material in a full bucket
In order to avoid danger of accidents, do not transport loads with a raised
loader unit!
Always dump in the attachment a little towards the machine, carry it as close
as possible to the ground and bear in mind the required ground clearance!
If it is dumped in, the bucket is moved parallel to its initial position as the loader
unit is raised! If the bucket is unintentionally dumped in to the limit in the raised
position, material can fall over the rear of the bucket!
☞ In the raised position, do not dump in a loaded bucket fully to the limit
☞ Slightly readjust (dump out) the bucket if necessary
☞ In case of a bulky load:
• Secure the load and if necessary, fit the rear of the bucket
with a protection
• Install a protective FOPS screen (option) onto the cab
☞ Ensure good visibility of the material you want to pick up and of the work
and travel range
In order to avoid tipping over when driving or manoeuvring on slopes with a
full bucket, dump in the bucket fully and and set the loader unit to transport
position!
☞ Whenever possible, drive in reverse when transporting a bucket loaded
with material down a steep slope
Driving on public roads with a full bucket is not allowed in Germany!
Get informed on and follow the legal regulations of your country.
To Next Page
Loading...
