BA 35101/02/ 03 EN – Edition 1.0 * 35101_02_03b110.fm 1-5
Introduction
1.7 Fields of application and using a wheel loader with an attachment
The attachments will decide in the first place how the machine is used.
In order to avoid damage to the machine, only the attachments listed in the
table have been authorised for installation on the machine.
Mounting attachments other than Kramer is only allowed if they correspond
to the description in chapter “Operation”, “Equipping the machine with a
standard bucket” on page 3-66, “Fitting a multipurpose bucket” on page 3-75
and “Fitting pallet forks” on page 3-85.
German road traffic regulations prohibit driving on public roads if the distance between the
front edge of the bucket and the centre of the steering wheel is over 3500 mm in transport
position.
The attachments complying with German road traffic regulations and the applicable provi-
sions are listed in the General Certification for Vehicles (Germany) or the data confir-
mation (Germany)!
Attachments listed neither in the General Certification for Vehicles (Germany) nor in
the Data confirmation (Germany) require a Separate Certification for Vehicles (Ger-
many) made out by the competent authority!
Get informed on and follow the legal regulations of your country.
Attachments with authorised material densities
Description of attachment
Wheel
loader
Part no.
(model)
Dimensions
mm (in)
ISO 7546 capacity
struck/heaped m³
Use
Standard bucket
(normal material)
351-01
1000102344
1
1000160648
1
1750 (68.90)
with teeth
1750 (68.90)
without teeth
0,55/0,65
Loosening, picking up, transporting
and loading loose or solid material
(material density ≤ p = 1.8 t/m³)
351-02
1000096388
1850 (72.83)
with teeth
0,65/0,75
1000137538
1
1850 (72.83)
without teeth
351-03
1000110166
1000110167
1750 (68.90)
with teeth
1750 (68.90)
without teeth
0,55/0,65
1000154547
1950 (76.77)
with teeth
0,75/0,851000245973
1
1950 (76.77)
without teeth
Standard bucket
(lightweight material)
351-01 1000137538
1
1850 (72.83)
without teeth
Picking up, transporting and load-
ing very lightweight material (mate-
rial density ≤ p = 1,3 t/m³)
351-02 1000096393
2
2050 (80.70)
without teeth
0,9/1,1
351-03 1000096394
1, 2
2150 (84.64)
without teeth
1,1/1,3
Picking up, transporting and load-
ing lightweight material (material
density ≤ p = 0,9 t/m³)
Standard bucket (super-
lightweight material)
351-01 1000096394
2
351-02 1000096397
2
351-03 1000187889
1, 2
2300 (90.55)
without teeth
To Next Page
Loading...
